Water pipes located above and below ground as part of a network servicing a town in Libya required live leak repair to seal cracks without disrupting supplies
Author: smccarthy@sylmasta.com
Case Study: Dairy Delivery Truck 466 International Engine Cracked Timing Cover Repair
Industrial Metal saves a Puerto Rico milk company spending $1000 on a new timing cover for one of their delivery trucks by repairing a crack through which oil was escaping
Case Study: Leaking Hydrogen Line Pipe Repair at Power Station in Puerto Rico
Leaking joints at either end of a hydrogen line installed as part of a new cooling system for a Puerto Rico power station required sealing before the pipe went into full service
Case Study: Filler Repair of 50mm Crack Between Toilet Waste Pipe & Bathroom Floor
A hole cut too big into a bathroom floor during renovations left a 50mm crack around the base of a toilet waste pipe, which required permanent sealing with a waterproof filler material
Case Study: Superfast Steel Epoxy Putty Used to Fix Rust Holes on a Classic Car
A classic car owner uses Superfast Steel Epoxy Putty to permanently fix rust holes which had developed on the metal frame of their vehicle in a quick, easy and cost-effective repair
Case Study: Leak Repair of a Bathroom Sink PVC Plastic Drain Pipe
Cracks in a PVC plastic pipe located in a cupboard underneath a bathroom sink undergo a quick and easy DIY repair by the property owner using Superfast Plastic Epoxy Putty Stick
Case Study: Reinforcement of 6 Metres of Corroded Steel Pipe in a Fire Station Pumping House
A 6 metre section of 150mm steel pipe including two 90 degree elbow bends at a fire station pump house is reinforced with SylWrap HD after being badly weakened by corrosion
Case Study: Using Epoxy Putty for Cracked & Damaged Brick Repair & Restoration
Bricks suffering from cracks, holes and missing chunks as a result of lime blow are seamlessly repaired using epoxy putty coloured with brick dust at a site in the south of England
Case Study: Repair of a Leaking 150mm Steel 90 Degree Elbow Bend at a Quarry Wash Plant
When a quarry in the UK could not fit a pipe repair clamp around a leaking 150mm steel 90 degree elbow bend, they instead used a SylWrap Pipe Repair Kit to seal the line
Case Study: Desalination Plant Partially Buried 3000mm FRP Discharge Return Pipe Repair
A desalination plant in Saudi Arabia needed to seal gaps between connecting rings left during installation of a 3 metre diameter FRP pipe before the facility could go online