Sylmasta CAE120 Multipurpose Superglue is a medium viscosity cyanoacrylate adhesive for general use. It forms instant bonds when sticking plastics, metal, porcelain, fine china, ceramics, jewellery and other materials, with a cure time of 3 seconds or less on non-absorbent surfaces.
CAE120 Superglue is used in repair and restoration, assembly, kit building and model making applications. The cyanoacrylate formulation of CAE120 Superglue enables it to bond difficult substrates in lower humidity situations.
When used with porous materials including wood, fabric and paper, CAE1500 Superglue has a cure time of less than one second.
It will cure in under 2 seconds on balsa and nitrile rubber. Cure speed on neoprene and EPDM is 3 seconds. Cure speed on PVC is 3–10 seconds, steel 10–20 seconds and polycarbonate 10–40 seconds. For specific cure times based on substrate, please see the Technical Data Sheet.
CAE120 Superglue sets clear and has a softening point of approximately 130°C. It achieves a full cure in 24 hours and is available in 20g or 500g bottles.
Ultra-Fine Nozzles can be attached to the 20g bottle for greater control, applying drops of superglue as small as 0.5mm to create cleaner, neater glue lines. Please contact Sylmasta for more information on Ultra-Fine Nozzles.
Sylmasta CAE120 Superglue is effective on surfaces including plastic, wood, rubber, porcelain, fine china, ceramics and jewellery. Parts requiring repair are held together whilst the superglue bonds, based on the cure time for the substrate.
To make an instant bond using CAE120 Superglue with non-absorbent materials, Superglue Activator is applied on top of the cyanoacrylate adhesive. Activator acts as an accelerator for the cure time of the superglue.
When a slightly longer work time is desired for more control when assembling parts, please see CAE1500 High Viscosity Superglue.
The higher viscosity of CAE1500 gives additional bonding time when used with non-absorbent materials; 5–10 seconds on PVC plastic and 25–40 seconds on steel, for example. CAE1500 is also more suitable for gap filling.
Benefits of CAE120 Multipurpose Cyanoacrylate Superglue
Rapid bonding of all materials
High performance in low humidity
Applications
General purpose bonding of plastics, metal, porcelain, fine china, ceramics
High viscosity cyanoacrylate superglue used to fill gaps and in applications where additional bonding time is desired. Cure time on steel is 25 to 40 seconds, offering a small window to adjust parts before bonding takes place.
Cure Time: 1–40 seconds, dependent on substrate Viscosity: 1250-1850cps Colour When Set: Clear
Low viscosity, surface insensitive cyanoacrylate superglue as thin as water which penetrates porous surfaces and flows easily into small, hard-to-access areas. Just one drop will wick into joints between parts, permanently bonding them together.
Cure Time: 3–40 seconds, dependent on substrate Viscosity: 2-6cps Colour When Set: Clear
Accelerates the cure time of any grade of Sylmasta Cyanoacrylate Superglue. It enables rapid adhesion between otherwise slower-to-bond substrates, and prevents porous surfaces absorbing lower viscosity superglues. Activator is available in 50ml bottles for application with a brush or 200ml aerosol for directly spraying onto parts requiring bonding.